The advantages and disadvantages of using aluminum wire and copper wire for water pump motors are as follows:Advantages and disadvantages of aluminum wire motorsAdvantages:Lower price: Aluminum is relatively cheaper than copper, so the cost of using aluminum wire motors is lower.Lightweight: The low

What causes the submersible pump to trip when powered on1. Electrical malfunctionShort circuit: Water ingress into the internal coils, cables, or junction boxes of the pump body can cause a short circuit. Use a multi-meter to measure the winding resistance (normally several ohms to tens of ohms, if

The reason for the sudden decrease in water output of the submersible pump1. Impeller or pump body flow channel blockageReason: Impurities (such as water grass, sediment) block the impeller or pump body flow channel, resulting in a decrease in flow rate and head. ‌Solution: Disassemble the pump and

Reasons for the pump body to heat up when using the water pump:‌1. Bearing damage: Bearing damage will increase friction, causing the pump body to heat up. Insufficient or excessive lubricating oil (grease) in the bearing, poor quality, mud, iron filings and other debris, and bearing clearance that

The main reasons why the submersible pump sometimes rotates and sometimes does not rotate include the following:1. Power supply problem: The submersible pump may have difficulty starting due to unstable power supply voltage or power failure. Low or high power supply voltage, damaged cables, poor con

1. Reason for water pump leakage(1) When installing the water pump, the water seal seat ring assembly was not installed properly, causing the water pump to continue leaking water. Due to the presence of a water blocking ring on the pump shaft corresponding to the inspection hole, when the water seal

How to deal with water pump blockage?Treatment methods for water pump blockage1. Disconnect the power supply or move it to a place without direct sunlight: First, ensure safety by disconnecting the power supply of the water pump or moving it to a place without direct sunlight. ‌2. Disassemble the in

SP stainless steel 304 well pump submersible deep well pump corrosion-resistant multi-stage impeller clean water pumping three-phase well pump Six reasons to choose our Dolay Pump Industry? Stainless steel outlet Stainless steel 304 pump body

Difference between clean water pump and sewage pump1. Different runner designThe sewage pump is used to pump sewage. In order to prevent clogging, it is mainly designed with large flow channel, so the head is generally not high.The clean water pump is pumping clean water, so the flow channel is smal