You are here: Home » Resource » News

Borehole water pump

The articles shown below are all about the Borehole water pump, through these related articles, you can get relevant information, notes in use, or latest trends about the Borehole water pump. We hope these news will give you the help you need. And if these Borehole water pump articles can't solve your needs, you can contact us for relevant information.
  • The Advantages And Disadvantages of Using Aluminum Wire And Copper Wire for Water Pump Motors
    2025-06-19
    The advantages and disadvantages of using aluminum wire and copper wire for water pump motors are as follows:Advantages and disadvantages of aluminum wire motorsAdvantages:Lower price: Aluminum is relatively cheaper than copper, so the cost of using aluminum wire motors is lower.Lightweight: The low
  • Pump Parts-The Difference between External And Internal Machine Seals
    2025-06-11
    The difference between external and internal machine seals1. Appearance2. Installation locationExternal mechanical seal refers to a mechanical seal installed outside the shaft end of the equipment, usually located outside the equipment and connected to the main body of the equipment through flanges
  • Reasons And Solutions for Oil Leakage in Submersible Pumps
    2025-05-16
    Reasons and solutions for oil leakage in submersible pumps1、 Reasons for oil leakageMechanical seal damageMechanical seals are key components in preventing oil leakage. If the seals age, wear, or are installed improperly, it can lead to oil leakage.Reason: Long term operation, impurities in water qu
  • What Causes The Submersible Pump To Trip When Powered on
    2025-05-08
    What causes the submersible pump to trip when powered on1. Electrical malfunctionShort circuit: Water ingress into the internal coils, cables, or junction boxes of the pump body can cause a short circuit. Use a multi-meter to measure the winding resistance (normally several ohms to tens of ohms, if
  • Methods To Prevent Damage To Water Pumps Caused by Prolonged Disuse
    2025-04-11
    Methods to prevent damage to water pumps caused by prolonged disuseDisassemble and storeIf disassembly is convenient, the water pump and pipeline can be removed and cleaned thoroughly.Check the bearingsCheck the ball bearings, and replace them if the inner and outer sleeves are worn, loose, the ball
  • Reasons for The Pump Body To Heat Up When Using The Water Pump
    2025-04-07
    Reasons for the pump body to heat up when using the water pump:‌1. Bearing damage: Bearing damage will increase friction, causing the pump body to heat up. Insufficient or excessive lubricating oil (grease) in the bearing, poor quality, mud, iron filings and other debris, and bearing clearance that
  • Reasons for Excessive Power Consumption of Submersible Pumps
    2025-03-26
    Reasons for excessive power consumption of submersible pumps 1. Overheating of bearings: The power machine and water pump shaft are subjected to excessive radial force, resulting in an increase in load and bearing heating.2. Too tight packing: Too tight packing makes the water diversion ditch not sm
  • The Main Reasons Why The Submersible Pump Sometimes Rotates And Sometimes Does Not Rotate
    2025-03-11
    The main reasons why the submersible pump sometimes rotates and sometimes does not rotate include the following:1. Power supply problem: The submersible pump may have difficulty starting due to unstable power supply voltage or power failure. Low or high power supply voltage, damaged cables, poor con
  • Reasons And Treatment Methods for Water Pump Leakage
    2025-03-03
    1. Reason for water pump leakage(1) When installing the water pump, the water seal seat ring assembly was not installed properly, causing the water pump to continue leaking water. Due to the presence of a water blocking ring on the pump shaft corresponding to the inspection hole, when the water seal
  • How To Deal with Water Pump Blockage?
    2025-03-01
    How to deal with water pump blockage?Treatment methods for water pump blockage1. Disconnect the power supply or move it to a place without direct sunlight: First, ensure safety by disconnecting the power supply of the water pump or moving it to a place without direct sunlight. ‌2. Disassemble the in
  • Total 2 pages  Go to Page
  • Go

Quick Links

Contact Details

MOBILE:0086-13867672347

ADD: NO.189 HENGSHI ROAD, HENGFENG INDUSTRY AREA, WENLING, TAIZHOU, ZHEJIANG PROVINCE,CHINA.

TEL: 0086-57686932269
CONTACT US
© 2021ZHEJIANG DOLAY PUMP INDUSTRY CO. LTD. All rights reserved.Site Map. T echnology by  leadong